Sichuan Bokda Precision Molding Co., Ltd.
Bokda---Your consultant on moldings. Our core policy is “Pursue excellent quality and outstrip customer expectations”.
Add to Cart
Cold Runner Custom Molded Plastic Parts Plastic Injection Moulded Parts OEM Parts
About the cold runner:
Cold runner injection molding is compared with hot runner injection molding. The pouring system is taken out with the product after cooling in the mold, removing the pouring cold material and trimming the gate can obtain the final product with inconspicuous pouring traces. Compared with the hot runner, the produced cold material needs to be crushed and recycled again, but the mold design is simple and widely used.
Product parameters:
| ould cavity | Germany 2316 with HRC 42-45 |
| Mould core | Germany 2316 with HRC 45-48 |
| Mould neck | Germany 2316 with HRC 45-50 |
| Valve Pin | SKD51 from Japan with HRC 58-60 |
| Valve Pin heat Isolation pad | America Dupont can withstand 350 degrees temperature |
| Hot runner nozzle | America Beryllium copper with HRC 37 |
| Mould manifold plate | H13 from America with HRC 35-38 |
| Mould other plate | P20 |
| Other Specification of the Mould | |
| Hot runner system | Hot runner system is made by our own factory, But the spare parts of the Hot runner is from Germany Hotest |
| PID controller | Made by our own factory |
| Guarantee for the Mould | 1 million shot times of 1 year |
| Free spare parts of the mould | Core set : 1set/ cavity: 1 Piece/ hot runner system: 1set/PID controller system: 1Set/ other easy broken spare parts for each 8cavities cap mould. |
| The life of the mould | 5-6years , Even in 10 years in good maintenance |
| Installation & Commission | Our technician can be the buyer' s factory to install and run the mould. But the buyer should bear all the cost for the technician' s trip(include the air ticket, the cost of the accommodation and the salary) |
Mould show:
Plastic injection products:
Our core policy is “Pursue excellent quality and outstrip customer expectations”.